Beneteau First 27 Se for sale in Palma de Mallorca Spain

Boat Overview

The Beneteau First 27 SE offers a modern and enjoyable downwind sailing experience, thanks to its innovative design and construction techniques. Ideal for families, it provides a comfortable cruising experience, exciting day sailing, and competitive performance in club races. This pocket-cruiser accommodates up to 6 persons and features a separate bow cabin, an open space saloon, a galley with freshwater, a fridge, and a classic marine toilet.

Covers

• Bimini Top
• Lazy Bag

Electrical Equipment

• Shore Power Inlet

Electronics

• Depthsounder
• Log-Speedometer
• Wind Speed and Direction
• Plotter
• Autopilot
• Compass
• GPS

Inside Equipment

• Manual Bilge Pump
• Marine Head
• Battery Charger

Outside Equipment/Extras

• Solar Panel

Rigging

• Tiller
• Hydraulic Winch

Sails

• Battened Mainsail
• Gennaker/Cruising Spinnaker
• Furling Genoa

Construction

The hull and deck are constructed using Vacuum Infusion of Vinyl ester resin, foam, and Soric GRP sandwich with unidirectional and biaxial laminates. The hull is reinforced with infused GRP stringers in the keel and bow sections. The hull and deck are molded in a single tone off-white, with a high traction non-skid molded deck. Carbon fiber beams are laminated on the keel box and glued to the deck to support mast compression and the keel hydraulic ram. The boat features two transoms hung balanced rudders made of GRP foam sandwich, red chainplates bolted to the main structural bulkhead, and all bolts, screws, and fittings are made of stainless marine grade stainless steel. The underwater areas are faired and ready for sanding, epoxy primer, and antifouling application.

Swinging Keel System

The swinging keel features an "elephant leg" lead bulb, a main steel structural element, and an epoxy GRP enclosure. Laminated areas of the keel are pre-painted with epoxy primer for easier antifouling treatment. It is operated by a manually operated hydraulic pump with a stainless steel hydraulic ram built into the carbon fiber mast support.

Deck Equipment

• 60 cm high stainless steel pulpit, pushpit, and six stanchions painted in matte black, with double lifelines
• Stainless steel bow and stern mooring cleats
• Stainless steel chain plates for side shrouds and forestay painted in matte red
• Four Wichard folding pad eyes for lifting straps at mid-two stations
• 2x Harken STA15 secondary halyard winches
• 2x Harken STA20 jib and gennaker trim primary winches
• 2x Spinlock winch feeder on the coachroof
• Two rope bags and two winch handle bags, Outils Océans & First branded
• Wide mainsail traveler installed over the tiller
• Carbon tiller with Spinlock EA1200DS tiller extension
• Laminated tempered glass windows on both sides of the hull
• An opening hatch of 58 cm x 58 cm / 23 x 23 inch for light ventilation and deck access to the mid-section compartment
• An opening hatch of 25.5 cm x 25.5 cm / 10 x 10 inch for front cabin ventilation
• Bow anchor locker with Dyneema J3 staysail attachment point on the deck
• Stern storage compartment cover
• Foldable outboard cockpit compartment with two top & one bottom cover and engine bracket for internal combustion outboard (not mounted)
• Manual bilge pump operated from the cockpit

Mast & Rigging

• CompoTech mast and boom with two sets of swept-back spreaders built in high-quality carbon fiber
• Ronstan Series 19 aluminium track for mainsail cars (cars not included; they are part of the mainsail option)
• All carbon parts UV protected
• Mast transport & storage bag
• Continuous 1x19 standing rigging with bottle screw adjusters
• Retractable carbon bowsprit controlled from the cockpit
• Dyneema pole-out control line
• Dyneema gennaker tackline
• 2:1 Dyneema mainsail halyard with Wichard MX8 halyard shackle
• Dyneema jib halyard
• 2:1 Dyneema staysail halyard
• Dyneema masthead gennaker halyard
• Dyneema fractional gennaker halyard
• 9x Spinlock clutches for halyards, mainsail reefs, and bowsprit control lines
• Ronstan blocks and cleats for mainsail, jibs, and gennakers control lines
• One tapered mainsheet with ball bearing low friction blocks
• Three mainsail reef lines
• Control line for the mainsail traveler
• 8:1 outhaul purchase led inside the boom
• 8:1 cunningham purchase
• 16:1 vang purchase
• Three jib sheets
• Spliced Dyneema jib inhaulers with a fixed length
• 2:1 jib downhaulers with control lines, cleats, and blocks
• Two tapered gennaker sheets with blocks
• Mast transport & storage bag

Electricity

• Custom electric control panel with five switches and smart Philippi LCD battery control display
• Remotely controlled master switch on the control panel
• Standard 12V and USB plugs in the saloon
• 12V 70AH AGM battery
• Ambiental indirect LED lights around the ceiling
• One mid-section and two front cabin battery LED lights
• Masthead LED navigation and anchor light
• Sentinel tracker to connect, monitor, and control boat systems remotely on your mobile phone with a 1-year subscription
• Pre-wiring for most of the available electrical options

Interior

The bulkheads and furniture are lightly covered with matte paint, with white gel coat on the molded parts for a light, clean, and low maintenance finish.

Front Cabin

• Double V-berth with insubmersibility volume underneath
• Opening hatch of 25.5 cm x 25.5 cm / 10 x 10 inch for front cabin ventilation

Mid-section Compartment / Wet Room

• An opening hatch of 58 cm x 58 cm / 23 x 23 inch for light ventilation and deck access to the mid-section compartment
• The base for chemical or flush toilet with monolithic reinforcements for valves on the starboard side

Saloon

• Bright and spacious saloon area with large Plexiglass companionway washboard and sliding hatch
• Dedicated storage place for washboard at the back of the companionway steps
• Benches on both sides of the saloon, divided into four wooden covers of the storage space underneath
• Main electric box and battery in aft port compartment and keel hydraulic pump under aft starboard compartment
• Padded back-supports with gimbal cooker holder attachment points on both sides and storage behind the nets
• Wide berths in the stern on both sides, with insubmersibility chambers underneath
• Front and aft keel box covers with table attachment point with a screw on the aft
• Electric boxes under the ceiling and under the companionway
• Extra storage room under the companionway and engine box for fresh-water tank or other systems, with cover
• Two ergonomically shaped wooden companionway steps
• Well insulated 40L icebox below bottom companionway step, with fridge compressor upgrade possibility
• Light grey EVA foam floorboards
• Shrouds attachments counter plates painted in matte red

Propulsion

MERCURY 9.9 HP OUTBOARD ENGINE WITH ELECTRIC STARTER:

• Mercury 9.9 HP outboard engine (short shaft, remote controls, electric starter), integrated into the cockpit engine compartment
• Throttle and gear remote control system with Teleflex commands, removable Spinlock handle, and push-pull cables
• Electric starter with key
• 6 A alternator for charging the battery
• Custom installation parts (engine foot rubber support, storage position padding)
• Standard Mercury 12 L fuel tank with connection hose
• Strap with attachment points for fixation of the petrol tank
• Complete installation and electric wiring

Sails & Rigging

FIRST 27 SE FACNOR FLATDECK FURLER FOR THE JIB (FD110):

• Facnor FD110 flatdeck furler with flat aluminium profile
• Spinlock clutch for furling line on the side of the cockpit
• Customised forestay toggle

BARTON RODKICKER/BOOMKICKER:

• Barton composite Boomstrut
• Prevents the boom from dropping into the cockpit or onto the coach roof
• Boom and mast foot reinforcement

ADJUSTABLE JIB INHAULERS:

• Adjustable jib inhauler for precise 3D trim of the jib
• 6:1 purchase on the coachroof
• Replacing standard fix-length jib inhauler and allowing active trim of the jib sheeting angle

FIRST 27 SE NORTH SAILS SQUARE TOP MAINSAIL:

• Square top mainsail with full battens and three reefs
• Durable and robust NPL Tour laminate material in light grey, triradial cut, 26.2 m2 / 282 sq ft
• Ronstan Series 19 Ball-Bearing Batten Car System for aluminium mast track

FIRST 27 SE NORTH SAILS J1 JIB FOR FURLER:

• J1 furling jib with vertical battens for Facnor FD110
• Durable and robust NPL Tour laminate material in light grey, triradial cut 19.5 m2 / 210 sq ft

FIRST 27 SE NORTH SAILS J3 FURLING STAYSAIL WITH FURLER:

• Furling J3 jib with structural luff to be hoisted on the dedicated 2:1 halyard
• Triradial cut, hydranet material
• Facnor FX 1500+ furler set with spliced continuous furling line
• Wichard MX6 halyard shackle

FIRST 27 SE NORTH SAILS A5 FRACTIONAL GENNAKER IN A CHOSEN COLOUR:

• Fractional gennaker, reacher, 64 m2 / 689 ft2
• Nylite 90 - Performance Ripstop nylon, 1.12 oz.
• Colour options – RED, WHITE or BLACK

Navigation & Electronics

ELECTRIC PUMP UPGRADE FOR HYDRAULIC KEEL SYSTEM:

• Upgrade of standard manual hydraulic system with 12V electric pump
• Double safety control switches on the electric panel
• Manual operation of the keel remains possible

COMPASS PLASTIMO CONTEST 101:

• Plastimo Contest 101 compass mounted on bulkhead next to companionway
• Compass light connected to navigation lights switch

SOLAR PACK:

• Sunbeam Tough series walkable 55W solar panel
• Placed on the cabin in front of the mast with connection cable hidden under the panel
• Smart MPPT solar panel regulator for up to 30% better panel efficiency and Bluetooth connectivity

WINDEX

GARMIN COASTAL PACK:

• GMI 20 large and bright 4” QVGA colour displays with LED backlighting, installed on the coachroof
• Airmar DST810 depth, speed and temperature transducer
• gWind race wired wind transducer
• External GPS 24xd antenna
• NMEA2000 backbone kit and wiring
• Dedicated switch on the control panel

GARMIN AUTOPILOT PACK:

• Underdeck autopilot installation, instantly available for use
• Reactor™ 40 Course Computer Unit with ECU 10 pack
• GHC 50 Autopilot Instrument for operation and control
• Reactor™ Autopilot Remote Control
• GRF 10 Rudder Feedback Sensor
• Raymarine mechanical linear drive, Type 1
• Wiring, installation cables, quadrant arm, and other assembly parts
• Dedicated switch for an autopilot on the control panel

GARMIN CHARTPLOTTER PACK:

• GPSMAP 723 touchscreen Chartplotter with high-resolution IPS display
• Supplied with Worldwide Base map, WITHOUT detailed regional charts
• Garmin Sailassist™ sailing features
• Installed on unique swinging bracket at the companionway, with adjustable angles for perfect visibility and inside use as well
• Wiring and dedicated control panel switch

GARMIN VHF 215I MARINE RADIO WITH AIS:

• Garmin VHF 215i AIS Marine Radio with standard Class D Digital Selective Calling (DSC) functionality
• Garmin AIS 800 Blackbox Transceiver, including VHF antenna splitter for Class-B AIS system
• External GA 38 GPS/GLONASS antenna
• SCOUT KM-10S VHF Fiberglass Antenna
• Wiring and dedicated control panel switch

230V CHARGING PACK:

• 230V charger with fuse
• External shore cable plug
• Shore cable + adapter to standard 230V plug
• Internal 230V plug

COOKER GIMBAL:

• Aluminium gas cooker gimbal optimized for Jetboil Flash cooker (not included)
• Can be fixed on the saloon back-supports on both sides

CLASSIC TOILET:

• ABS plastic bowl (only 3 kg / 6.61 lbs) by RM
• 30 L / 7.9 gallons unique blackwater tank, installed in the toilet compartment
• Plumbing with Trudesign valves

FIRST 27 SE COMFORT PACK IN A CHOSEN COLOUR:

• Faux leather cushions on the front V-berth and saloon benches
• A foldable wooden table on the keel-box
• Two foldable magnetic doors closing the toilet compartment and Sail locker panel in chosen faux leather colour
• Faux leather colour options – GREY and TURQUOISE

FIRST SE CREW BAGS (6 PIECES) IN A CHOSEN COLOUR:

• Water repellent PVC easy-to-hang FIRST SE crew bags
• Attachment points for four bags in the saloon and two in the front cabin
• FIRST SE handles in red
• Colour options – GREY, WHITE, BLUE and RED

MOORING PACK:

• Spade A60 aluminium anchor (4.5 kg / 10 lbs)
• 40 m/12 mm / 131’ 3”/0.47-inch rope for the anchor with first 10 m / 32’ 10” with lead insert
• Mooring lines 10m/12mm / 32’ 10”/0.47 inch with spliced ends
• 4x Outils Océan Custom square foam fenders with fixation ropes
• 4x LAZY BAG
• FURLING JIB COVER
• SUNSHADE WITH POLES

Transport & Commissioning