Realistically priced Brig Eagle 645 RIB, with 150 hp Mercury Verado outboard motor, which was built in late 2007 and commissioned in 2008. Its renowned performance and spacious open cockpit makes it a great choice for the water sports enthusiast or just a family day out on the water.
Dimensions
- Length overall: 21’1” (6.48 M)
- Beam: 8’2” (2.50 M)
- Draft: 1’0” (0.30 M)
-
Realistically priced Brig Eagle 645 RIB, with 150 hp Mercury Verado outboard motor, which was built in late 2007 and commissioned in 2008. Its renowned performance and spacious open cockpit makes it a great choice for the water sports enthusiast or just a family day out on the water.
Dimensions
- Length overall: 21’1” (6.48 M)
- Beam: 8’2” (2.50 M)
- Draft: 1’0” (0.30 M)
- Displacement (approx.): 1000 Kg
Tanks
- Petrol: 44 Gal (200 Lt)
- Fresh water: 16 Gal (75 Lt)
Mechanical and electrical
- 150hp Mercury Verado 4 stroke outboard motor with 3 bladed s/s propeller gives 40 knots maximum speed
- Full engine instrumentation (including speedlog and clock), single lever control and kill switch
- Hydraulic steering
- 12 volt battery (2016) with isolator switch
- Electric bilge pump with float switch
- Fresh water electric shower
- Horn
Navigation equipment
- Icom IC-M421 DSC VHF radio
- Danforth compass
- Navigation lights
Cockpit layout
- Spacious self-draining open cockpit with anti-skid deck surface
- Raised sundeck forward
- Steering console with wind screen, forward facing seat and s/s grab rail
- Double folding bolster seat for helm and co-pilot
- Aft full width bench seat with folding table on back of bolster seat
- Fully moulded engine well and GRP tube ends with anti-skid boarding steps
- Good stowage in console and in lockers under seats / sundeck
Equipment
- Overall cover
- S/s folding boarding ladder (not fitted)
- S/s ski pole
- Ski eyes (2)
- Aft s/s pop-up cleats (2)
- S/s grab rails on tubes (6)
- Foot pump for tubes
- Built in davit lifting points
- Forward sundeck cushions (2015)
- Console and helm seat cover (2015)
- Bow roller
- Bruce anchor with chain and warp
- Warps and fenders
- Flare pack
Disclaimer
In this case we are acting as Brokers only. The Owner is not selling in the course of a business. Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed. The particulars are intended only as a guide and they do not constitute a term of any contract. A prospective Purchaser is strongly advised to check the particulars and where appropriate at his own expense to employ a qualified Marine Surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability for such engine on our part.
