hobbyist Ile Disko for sale in Le Marin Martinique

Very nice integral lifting keel boat, with twin rudders from 1996 built in steel.

Successful amateur construction, scrupulous respect of the plans of the architect Gilbert Caroff, visible in Martinique, French pavilion, European VAT paid.

Accommodations:

Three cabins

Six berths

One double at the front

Two forward single beds with storage chests underneath

Charts table on port

Galley long shape on port side in the passageway

Shower room with Lavac marine toilet, and washbasin on starboard side, no shower.

Aft saloon with table and bench

One large aft bed behind the saloon

Sailing compartment, with storage underneath and on the sides

Under the cockpit:

Central storage, accessible galley passageway.

Under the floor:

Stainless steel water tanks 2X180 L

Pressurized water

Galley:

One double stainless-steel sink with drainer

Work plan,

Eno gas oven

Pressurized water

Sails and rigging:

Z Spars mast 15.00 m. 2 stages of spreaders.

Boom 5.00 m.

Baby stay for stay sail.

New 2022 Elvström furling mainsail in mast 34 m2.

New 2022 Furling genoa 60 m2

Genoese staysail 25m2

Stay sail 20m2 with reefing for storm jib.

New 2022 asymmetrical spinnaker on furler

Winches:

Two Andersen ST 46 In cockpit  

Two Andersen ST 40 in cockpit

Two Meisner 16 standards in cockpit

One Andersen ST 12 on port on the mast

One Andersen ST 40 on starboard on mast

One Andersen 22 central for main sail sheet traveler

Wind vane.

Electronics:   

Two portables GPS.

One fixed VHF.

One portable VHF.

Log, speedometer, graphic depth sounder.

SSB Antenna receiver 6m.

Merveille Radar Detector

New Mac Murdo Smart find EPIRB.

Radio CD player in saloon

12v screen with Raspberry pi for open CPN

Electrical:

Two solar panels 300w

Engine battery 1 X 100 A

Services batteries 3 X 100 A

Deck:

Lofrans’ Tigre 1200w electric windlass with remote control at the windlass and helm station

Spade 25 Kg main anchor with 12 mm chain 60 m

Brittany 20 kg second anchor

Stainless steel chain box under the windlass.

Arch for solar panels with dinghy davits.

Aft platform with swim ladder

Additional:

Bombard container life raft 6 peoples Last servicing 2021 

Flex O fold Two-Blade Replacement Propeller, 50cm Diameter.

Full details (Fittings, cowls, various dropouts, cockpit floor) are made of 316 stainless steel, 316 stainless steel fillet welding.

On the port and starboard sides, stainless steel davit support. Epoxy CP profiled daggerboard controlled by a winch line from the cockpit.

Ertalon leeboard axe/diameter 80mm

SEEIMI hydraulic steering  

The two rudders are coupled by a stainless-steel turnbuckle bar.

Piston and bypass accessible behind the saloon seat

Work carried between 2021 and 2023:

Sandblasted hull in 2023

Protection by six layers of jota sealant (Jotun)

Two coats of vinyl paint and 3 coats of hard matrix (Jotun)

New distribution belt and water pump

Engine refit in 2022

2021 starter and alternator

Exchanger flushed; gaskets changed.

Pulley 200 mm for shaft alternator, shaft diameter 35mm aluminum propeller diameter 50 mm

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.