LENGTH:
27.0 ft.
|
YEAR:
1976
LOCATION:
Troon
OFFERED BY:
Network Yacht Brokers
$5,000
LENGTH:
24.02 ft.
|
YEAR:
1981
LOCATION:
Ketchikan, Alaska
OFFERED BY:
Pop Sells
$5,500
LENGTH:
25.0 ft.
|
YEAR:
1982
LOCATION:
Arnold, Maryland
OFFERED BY:
Annapolis Sailyard
LENGTH:
29.99 ft.
|
YEAR:
1985
LOCATION:
Oyster Bay, New York
OFFERED BY:
Pop Sells
$41,150
LENGTH:
27.99 ft.
|
YEAR:
2003
LOCATION:
Grapevine, Texas
OFFERED BY:
Pop Sells
$17,900
LENGTH:
27.0 ft.
|
YEAR:
1983
LOCATION:
Saint Petersburg, Florida
OFFERED BY:
Pier One Yacht Sales
$12,900
LENGTH:
27.0 ft.
|
YEAR:
1989
LOCATION:
Key Largo, Florida
OFFERED BY:
Pop Sells
$17,500
LENGTH:
27.0 ft.
|
YEAR:
1979
LOCATION:
Spencer, West Virginia
OFFERED BY:
Pop Sells
Boat not available.
LOCATION
Troon S07 United Kingdom
YEAR
1976
LENGTH
27.56 ft.
Condition
Used
Name
Arachne
Year
1976
Make & Model
Newbridge Spinner 28
Boat type
Sail
Length
27.56 ft.
Fuel Type
Diesel
Location
Troon S07 United Kingdom
Beam
9.84 ft.
Fresh Water Tanks
15.06 gal
This Newbridge Spinner 28 is ideal for someone to take on as a project. It has been stored ashore for the last 10 years but has suffered from neglect and needs a new owner to breathe some life into her. A new Yanmar 1GM10 diesel engine was fitted many years ago and rarely used.
Originally designed as an IOR 1/2 tonner. Being sold as is and offers will be considered for this Newbridge Spinner 28.
This Newbridge Spinner 28 is ideal for someone to take on as a project. It has been stored ashore for the last 10 years but has suffered from neglect and needs a new owner to breathe some life into her. A new Yanmar 1GM10 diesel engine was fitted many years ago and rarely used.
Originally designed as an IOR 1/2 tonner. Being sold as is and offers will be considered for this Newbridge Spinner 28.
Forward sail locker and storage, opening hatch. Sea toilet located under the platform. Sink to port, hanging lockers to port and starboard. Through to the saloon with bench settees to port and starboard, both with trotter boxes to be used as single berths
Galley to port with Plastimo 2 ring gas stove with grill, storage, sink with cold water supply. Chart table to starboard, port and starboard quarter berths. Engine access under companionway.
Garmin GPSMap 451s series plotter (not connected)
Standard Horizon Eclipse GX1200E DSC VHF radio
Furuno GPS Navigator
Clipper Duet log and depthClipper wind
Tillerpilot
Saloon and navigation lights wiring not connected
Main sail
Genoa
Storm jib
Working jib
Reacher
Spinnaker
Two Lewmar 25 winches
Two Lewmar 8 winches
Mast halyard winch
Yanmar 1GM10 9hp diesel engine
Battery on board not connected
Suzuki 2hp two stroke outboard
Gas heater
Sprayhood on stainless steel frame
Tiller steering
Lockers
Cockpit dodgers
Stainless steel pulpit
Stainless steel pushpit quarters
Stanchions with twin guard wires
Manual anchor windlass
Anchor with chain
Bow roller
Fenders
Lifejackets
Horseshoe lifebuoy
This boat has been on the hard standing for the last ten years and has suffered from being left unattended during this time. It is being sold as is, no equipment has been tested to check if in working order. The engine, a Yanmar 1GM10, was installed professionally some years ago by the Yanmar agent at that time and has had very little use.
Keel bolts checked in 2017 and found to be in good condition.
HULL
Hull Material
fiberglass
OTHER
Fuel Tanks Capacity
25.1 gal
The Newbridge Spinner 28 is 28 feet long and has a 9.8 feet beam. The Newbridge Spinner 28 is made of fiberglass.