This Robber III-E is the cruising version of the well-regarded racer. She is therefore a fast Cruiser with a much better standard of interior fit-out than the racing version. There is no doubt that this version also performs very well; like all Robbers she will outperform many larger boats.
The overall condition of this particular boat is good with some nice upgrades including Furlex reefing system, new stack pack, keel bolts replaced.
This Robber III-E is the cruising version of the well-regarded racer. She is therefore a fast Cruiser with a much better standard of interior fit-out than the racing version. There is no doubt that this version also performs very well; like all Robbers she will outperform many larger boats.
The overall condition of this particular boat is good with some nice upgrades including Furlex reefing system, new stack pack, keel bolts replaced. She is sensibly priced to sell quickly.
A 2017 survey is available upon request.
Note: Offers on the asking price may be considered.
Accommodation
The accommodation offers up to six berths. In the forecabin, V berth with opening hatch to deck, Jabsco marine toilet beneath. In saloon, small galley area to starboard with Plastimo double burner hob (currently disconected). Two settee berths with drop down table between. Various storage lockers
Spars and Sails
Fractionally rigged sloop. Anodised aluminium mast and boom. Stainless steel standing rigging. Backstay adjuster. Terylene running rigging. Slab reefing mainsail. Furlex headsail furling system. Lines led aft to cockpit. Two halyard winches. Two sheet winches. Two spinnaker winches. Spinnaker pole
- Mainsail
- Genoa
- 3 x spinnakers
- various other headsails
Deck Equipment
- Anchor with chain and warp
- Self draining anchor stowage locker
- Stainless steel pulpit, pushpit, stanchions and guardwires
- Stack pack mainsail cover - Elite Yacht covers - new
- Various warps and fenders
Mechanical Systems
- Yamaha 6hp 2 stroke long shaft outboard - last serviced in 2019 including oil and impeller but dry stored since
Electrical Systems
12v battery charged via Ctec smart charger. Electrical distribution panel. Cabin lighting.
Navigation Equipment
- Twin Plastimo bulkhead mounted steering compass
- Wayfarer depth sounder
- Garmin GPS 2 colour chart plotter
- Nasa Clipper Depth sounder
- Nasa Clipper wind system
- Navigation lights
Safety Equipment
- 2 x Fire extinguisher
- Fire Blanket
- 2 x Manual bilge pump
- First aid kit
- Fog horn
Construction
Robber 3E built in 1977 by BEBS Marine to a design by Bernt Lindquist / Peter Ståhle / S. Jardine. White GRP hull with rubber rubbing strake. White GRP superstructure with grey painted non-slip to decks. Fin keel. Transom hung rudder. Tiller steering. Aft self-draining cockpit.
The company normally acts as brokers for the vendor who unless otherwise stated, is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.
General note on safety equipment: Any safety equipment such as liferaft, fire extinguishers and flares etc., are usually personal to the current owner(s) and if being left on board as part of the sale of a used vessel, may require routine servicing, replacement, or changing to meet a new owner’s specific needs.
