Custom C-R 38 for sale in Beaufort, North Carolina United States of America

Custom "one-off" design racer/cruiser.  "Divine" was designed by Heinritz Yacht Design and built by Schroder Shipyard in Germany.  The superior build quality id evident throughout the boat.  "Divine" offers a unique combination of sleek modern racing design and the amenities of a cruising yacht. 

OWNER READY TO MOVE THIS BOAT - MAKE AN OFFER TODAY!

Custom "one-off" design racer/cruiser.  "Divine" was designed by Heinritz Yacht Design and built by Schroder Shipyard in Germany.  The superior build quality id evident throughout the boat.  "Divine" offers a unique combination of sleek modern racing design and the amenities of a cruising yacht. 

OWNER READY TO MOVE THIS BOAT - MAKE AN OFFER TODAY!

Below Deck

• Large V-berth forward with two hanging lockers and an opening overhead hatch
  Spacious salon with a comfortable settee starboard and a center-line folding table
  L-shaped settee to port
  Galley to port with stove/oven, refrigerator, S/S sink with pressure water and ample storage
  Large double berth aft of the galley with a large hanging locker
  Head is starboard of the galley
  Aft storage can double as a large berth

Deck and Hull

• PVC cored epoxy directional E-glass hull
  Teak deck with plywood/E-glass epoxy composite
  Bottom – 4 layers of Interprotect 2000 E Barrier coat with 1 layer of Shark White Micron CSC antifouling
  Keel – Carbon fiber / steel composite with 4400# lead ballast
  Rudder – E-glass / carbon fiber / epoxy composite with stainless steel shaft
  Stainless Steel stanchions and life lines
  Jefa Steering Systems helm – teak
  Bruce anchor and Fortress anchor
  Boat cradle – fully adjustable 6 stand winterizing/haul out galvanized cradle

Sails and Rigging

• Main sail – Omar Sailmakers, carbon/mylar – 2012
  #1 – Omar Sailmakers, carbon/mylar – 2013
  #2 – Segelform, mylar/pentex – 2003 (orignially #1, recut to #2)
  #3 – Doyle Stratis, kevlar/mylar – 2010
  #4 – Technora – 2003
  Spinnaker – Segelform – 150 m2 (1600 sq ft) .75oz leaches, .5oz center section – 2003
  Spinnaker – Radtke – 105 m2 (1130sq ft) 2oz heavy air spinnaker – 2003
  Facnor RC low profile furler
  Mast – 9/10 alluminum John Mast DK mast with triple spreaders, top diamonds and rod shrouds.
  Boom – Carbon fiber main boom with spinnaker pole
  Boom vang
  Two Harken #48 primary winches
  Two Harken #40 secondary winches
  Two Harken #40 cabin top winches
  Dynema running rigging

Navigation Electronics

• Lowrance GlobealMap 7200C chartplotter
  Silva NX Wind data with wired wind transducer
  Silva NX Sea data (depth, log temp) with transducers
  Silva VHF with DCS (tied into chartplotter)
  Compass

Electrical

• Dual house batteries, – new 2016
  Dedicated starting battery
  Battery charger – 220 volt with 120v/220v transformer

Owner’s Notes

Divine was hauled ~6 years ago and although the engine cylinders were preserved, the engine, fuel system and electronics need attention before launching. The only known issue with the engine is a leaking exhaust
gasket. Also, since the boat has been sitting quite a long time in the same position, the sun has burned the paint on the starboard facing deck area as well as the cockpit floor teak imitation.

• *Lombardini LDW1003 29hp engine (current Kohler)What needs to be addressed:
  Engine exhaust seal replacement
  Compartments clean up
  Check/redo window caulking
  Cockpit floor

Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

Note: Existing safety gear conveys. Pyrotechnics out of date