OFFERED BY
Clarke & Carter Yacht Brokers
LOCATION
Burnham Yacht Harbour CM0 8BL United Kingdom
YEAR
1995
LENGTH
25.43 ft.
Condition
Used
Year
1995
Make & Model
Seaward 25
Boat type
Power
Length
25.43 ft.
Location
Burnham Yacht Harbour CM0 8BL United Kingdom
Beam
8.07 ft.
Draft
2.49 ft.
LWL
22.08 ft.
The Seaward 25 is a popular semi-displacement motor cruiser, deservedly sought after thanks to its excellent sea keeping, practical layout and high build quality. Ranger is a good example of the Seaward 25 and has clearly been well maintained. Her impressive specification includes electric windlass, radar, autopilot, heating, full cockpit cover and more.
The Seaward 25 is a popular semi-displacement motor cruiser, deservedly sought after thanks to its excellent sea keeping, practical layout and high build quality. Ranger is a good example of the Seaward 25 and has clearly been well maintained. Her impressive specification includes electric windlass, radar, autopilot, heating, full cockpit cover and more. Her twin Yanmar 75hp engines were removed from the boat in 2018 for new engine mounts and given a Yanmar 1,000 hour service.
Viewing by appointment only at our Essex office onor via email - essex@clarkeandcarter.co.uk
Accommodation
The cosy cabin has a double vee berth forward with central table which can be dropped to form a double berth with stowage in various lockers and shelves. Aft to starboard is a well designed galley consisting of a Plastimo Neptune two burner gas cooker with grill and oven, stainless steel sink with pressurised hot and cold water supply, folding top to give additional worktop space and good stowage. To port is a separate heads compartment which has a Jabsco marine toilet and moulded basin with pressurised hot and cold water supply. Teak interior woodwork, light grey linings, and navy blue upholstery (upholstery new 2018) combine to create a feeling of traditional high quality workmanship and makes an ideal setting for a couple looking for long weekends away in comfort. Moving aft to the wheelhouse, a comfortable helm and folding navigators chair are complimented by the large, practical cockpit which can be closed off with aluminium folding doors. The cockpit is fitted with port and starboard bench seats and a single bench seat aft. Eberspacher diesel fired warm air heating with outlets in cabin and wheelhouse.
Mechanical Systems
Located below two insulated engine boxes in the cockpit, two Yanmar 4JH2-HTE four cylinder, 75hp turbo charged diesel engines. Freshwater cooled via heat exchangers. Twin lever controls with electric start. Twin 130L stainless steel fuel. Shaft drive with Ambassador Stripper rope cutters via P-brackets to twin three blade propellers. Twin bronze rudders. Bennett electric trim tabs. Vetus exhaust alarms.
The engines are in good cosmetic condition and have proved faultlessly reliable during current ownership. The engines were removed in 2018 for the engine mounts to be replaced and were given a thorough 1,000 hour service by Yanmar agents, repainted and refitted including the new mounts, skin fittings and one new exhaust elbow. The propeller shafts were replaced in 2021 and fitted with Tides Marine shaft seals and new cutlass bearings. The engines were last serviced (including new turbo unit) in October 2023 and are currently reading just under 1,450 hours total run time.
Electrical Systems
2 x 12v batteries charged via engine alternator. Electrical distribution panel. Full cabin lighting. Shore power system with immersion heater, Victron EasyPlus battery charger/inverter and ring main.
Deck Equipment
Navigation Equipment
Safety Equipment
Construction
Seaward 25 built in 1995 by Seaward Marine Ltd, Guernsey to a design by Arthur Mursall (TT Boat Designs). GRP semi-displacement hull in dark blue gelcoat laid up to a commercial specification. Hull professionally resprayed in 2018. White GRP superstructure and decks with Treadmaster type non-slip surfaces. Wheel steering to twin rudders. Teak lower and rubber upper rubbing strakes. Stainless steel transom boarding ladder. Two midship cleats.
Disclaimer
The company normally acts as brokers for the vendor who unless otherwise stated is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.General note on safety equipment: Any safety equipment such as liferaft, fire extinguishers and flares etc., are usually personal to the current owner(s) and if being left on board as part of the sale of a used vessel, may require routine servicing, replacement, or changing to meet a new owner?s specific needs.
ENGINE 1
Fuel Type
Diesel
Tankage
150
Engine Tankage
150
HULL
Designer
Arthur Mursell (TT Designs)
Hull Material
fiberglass
OTHER
Displacement(kgs)
3000.0
The Seaward 25 is 25 feet long and has a 8.1 feet beam. The Seaward 25 is made of fiberglass.
$56,226
LENGTH:
25.0 ft.
|
YEAR:
2003
LOCATION:
Swale Marina, Kent
OFFERED BY:
Network Yacht Brokers
$50,034
LENGTH:
24.93 ft.
|
YEAR:
1995
LOCATION:
Falmouth
OFFERED BY:
Red-Ensign
$28,500
LENGTH:
24.51 ft.
|
YEAR:
1988
LOCATION:
Stuart, Florida
OFFERED BY:
Rick Obey Yacht Sales
$86,900
LENGTH:
25.0 ft.
|
YEAR:
2015
LOCATION:
Stuart, Florida
OFFERED BY:
Manatee Pocket Yacht Sales
$269,000
LENGTH:
25.0 ft.
|
YEAR:
2022
LOCATION:
Barrington, Rhode Island
OFFERED BY:
Striper Marina
$165,000
LENGTH:
25.0 ft.
|
YEAR:
2017
LOCATION:
Long Beach CA
OFFERED BY:
Denison Yacht Sales